Changeset aa2edb2 in sasmodels for sasmodels/models/elliptical_cylinder.py

Timestamp:

Mar 17, 2016 9:07:04 AM (8 years ago)

Author:

gonzalezm

Branches:

master, core_shell_microgels, costrafo411, magnetic_model, release_v0.94, release_v0.95, ticket-1257-vesicle-product, ticket_1156, ticket_1265_superball, ticket_822_more_unit_tests

Children:

4373d62

Parents:

d634601

Message:

Removing hardcoded figures to be replaced by autogenerated ones

File:

• sasmodels/models/elliptical_cylinder.py (modified) (1 diff)

sasmodels/models/elliptical_cylinder.py

@@ -64 +64 @@
 ----------
 
-Validation of our code was done by comparing the output of the 1D calculation to the angular average of the output of
-the 2D calculation over all possible angles. The figure below shows the comparison where the solid dot refers to
-averaged 2D values while the line represents the result of the 1D calculation (for the 2D averaging, values of 76, 180,
-and 76 degrees are taken for the angles of |theta|, |phi|, and |bigpsi| respectively).
+Validation of our code was done by comparing the output of the 1D calculation to the 
+angular average of the output of the 2D calculation over all possible angles. 
 
-.. figure:: img/elliptical_cylinder_validation_1d.png
-
-    Comparison between 1D and averaged 2D.
-
-In the 2D average, more binning in the angle |phi| is necessary to get the proper result. The following figure shows
-the results of the averaging by varying the number of angular bins.
+In the 2D average, more binning in the angle |phi| is necessary to get the proper result. 
+The following figure shows the results of the averaging by varying the number of angular bins.
 
 .. figure:: img/elliptical_cylinder_averaging.png