Save Project doesn't save state of simultaneous fit panel

[ajj]

Having gone through the pain of setting up a simultaneous fit, that state should be saved with the project.

[butler]

Again no man-power willing to look at the save and report issues so moving to wishlist for now

[butler]

will need to much of a refactor to do for 4.0

[krzywon]

I have a working save state for the simultaneous fit panel pushed to the wx_save_simfit branch on git. I am working on loading it now.

[Jeff Krzywon <krzywon@…>]

In e89aed5c946bf39b3cb963b0c7805341c30d2432/sasview:

#189: Can now open the simultaneous and constrained fit panel through a save state, but the constraint loading is still broken.

[Jeff Krzywon <krzywon@…>]

In 4fea1df3346e74844ba5587f0cf0192bc0922373/sasview:

#189: Loading in all contraints now, but can have conflicts with already loaded data.

[krzywon]

In 998ca90ad87500d7d5fb3f4eb13105752a2f2952/sasview:

#189 #12 Saving and loading project now fully saves and loads a simultaneous fits. Loading a project will reset Sasview state to its base state (with a warning). One error on load to fix before calling this finished.

[GitHub <noreply@…>]

In 60df6c144a7cccfd4d8c99cedca75d5566f1c709/sasview:

Merge pull request No. 13 from SasView?/wx_save_simfit

wx Saving Simultaneous and Constrained Fitting Panel

Closes #189 & closes #12

[smk78]

Fix verified.

Though I do note that the STATE of the model parameters is not saved; so when you re-open the project all parameters in all FitPages are unchecked by default. The only slight issue with this is that the Open Project also takes you to the Const & Simul Fit page where it is tempting to just click Fit… If you do so the Fit button turns to Stop giving you the IMPRESSION it is fitting when in fact it isn't doing a bean. The first time I did this I felt a bit of a numpty for spending a few mins sat watching SasView do absolutely nothing!