Changes in doc/guide/resolution.rst [8d2df05:db1d9d5] in sasmodels

File:

• doc/guide/resolution.rst (modified) (3 diffs)

doc/guide/resolution.rst

@@ -1 +1 @@
 .. resolution.rst
 
-.. This is a port of the original SasView html help file sm_help to ReSTructured 
+.. This is a port of the original SasView html help file sm_help to ReSTructured
 .. text by S King, ISIS, during SasView CodeCamp-III in Feb 2015.
 
@@ -17 +17 @@
 resolution contribution into a model calculation/simulation (which by definition
 will be exact) to make it more representative of what has been measured
-experimentally - a process called *smearing*. The Sasmodels component of SasView 
+experimentally - a process called *smearing*. The Sasmodels component of SasView
 does the latter.
 
@@ -32 +32 @@
 
 .. note::
-    Problems may be encountered if the data set loaded by SasView is a 
-    concatenation of SANS data from several detector distances where, of 
-    course, the worst Q resolution is next to the beam stop at each detector 
-    distance. (This will also be noticeable in the residuals plot where 
-    there will be poor overlap). SasView sensibly orders all the input 
-    data points by increasing Q for nicer-looking plots, however, the dQ 
-    data can then vary considerably from point to point. If 'Use dQ data' 
-    smearing is selected then spikes may appear in the model fits, whereas 
+    Problems may be encountered if the data set loaded by SasView is a
+    concatenation of SANS data from several detector distances where, of
+    course, the worst Q resolution is next to the beam stop at each detector
+    distance. (This will also be noticeable in the residuals plot where
+    there will be poor overlap). SasView sensibly orders all the input
+    data points by increasing Q for nicer-looking plots, however, the dQ
+    data can then vary considerably from point to point. If 'Use dQ data'
+    smearing is selected then spikes may appear in the model fits, whereas
     if 'None' or 'Custom Pinhole Smear' are selected the fits look normal.
-    
-    In such instances, possible solutions are to simply remove the data 
-    with poor Q resolution from the shorter detector distances, or to fit 
+
+    In such instances, possible solutions are to simply remove the data
+    with poor Q resolution from the shorter detector distances, or to fit
     the data from different detector distances simultaneously.