source:
sasmodels/doc/guide/magnetism/magnetism.rst
@
a03fad8
Last change on this file since a03fad8 was 990d8df, checked in by Paul Kienzle <pkienzle@…>, 8 years ago | |
---|---|
|
|
File size: 2.9 KB |
Polarisation/Magnetic Scattering
- Models which define a scattering length density parameter can be evaluated
- as magnetic models. In general, the scattering length density (SLD = $beta$) in each region where the SLD is uniform, is a combination of the nuclear and magnetic SLDs and, for polarised neutrons, also depends on the spin states of the neutrons.
For magnetic scattering, only the magnetization component $mathbf{M_perp}$ perpendicular to the scattering vector $mathbf{Q}$ contributes to the magnetic scattering length.
The magnetic scattering length density is then
where $gamma = -1.913$ is the gyromagnetic ratio, $mu_B$ is the Bohr magneton, $r_0$ is the classical radius of electron, and $sigma$ is the Pauli spin.
Assuming that incident neutrons are polarized parallel (+) and anti-parallel (-) to the $x'$ axis, the possible spin states after the sample are then
No spin-flips (+ +) and (- -)
Spin-flips (+ -) and (- +)
If the angles of the $Q$ vector and the spin-axis $x'$ to the $x$ - axis are $phi$ and $theta_{up}$, respectively, then, depending on the spin state of the neutrons, the scattering length densities, including the nuclear scattering length density ($beta{_N}$) are
and
where
Here, $M_{0x}$, $M_{0x}$, $M_{0z}$ are the x, y and z components of the magnetization vector given in the laboratory xyz frame given by
and the magnetization angles $theta_M$ and $phi_M$ are defined in the figure above.
The user input parameters are:
M0_sld | = $D_M M_0$ |
Up_theta | = $theta_{up}$ |
M_theta | = $theta_M$ |
M_phi | = $phi_M$ |
Up_frac_i | = (spin up)/(spin up + spin down) neutrons before the sample |
Up_frac_f | = (spin up)/(spin up + spin down) neutrons after the sample |
Note
The values of the 'Up_frac_i' and 'Up_frac_f' must be in the range 0 to 1.
Note
This help document was last changed by Steve King, 02May2015
- Document History *